ballast with parameter adjustment and remote control for four 4-pin UV-lamps, lamp power up to 325W

lamp ower: up to 325 W

lamp current: up to 2,2 A

Features

  • preheat start ballasts for optimal lamp operation with adjustable operation parameters
  • fourfold device - powers four lamps, independent lamp operation even if one lamp is defective or disconnected
  • adjustable preheat and operation parameters settings for use in different environmental conditions
  • controllable via PLC or ZED ZCON control units, allows dimming, using remote mode the status relay wiring can be omitted
  • lamp and ballast status indication
    - green, red and yellow LEDs
    - ModBus/ZCON status request
    - optional: potential free relay contacts
  • up to 30 m cable length possible
  • local operation and digital remote control
  • lamp operation control via RS485 using ModBus or ZCON protocol, optional:
    - ethernet interface
    - dimming using analog 4...20mA/0...10V interface
  • metal housing, designed for optimal thermal flow
  • push-in contacts for quick installation
  • enhanced protection
    - power range control
    - undervoltage protection
    - overtemperature protection
  • high efficiency
  • active power factor correction (PFC)
    low THD according to EN 61000

Technical Specification

supply voltage: 230V AC ± 10% /45-65Hz (115V AC types on request)
efficiency: >90%
operation temperature: max. 50°C (122°F) at TC-point (ballasts are overtemperature protected)
ambient temperature: 0 - 40°C (32 - 104°F)
IP code: IP20
dimensions (LxWxD): 269 x 317 x 83 mm (10.57 x 12.46 x 3.27 inch)

UV lamp types

  • GIA1554T5LCA
  • GIA1554T6LCA
  • GIA1554T6LCA/320
  • GPHA1554T5L
  • GPHA1554T6L
  • GPHHA1554T6L
  • GPHHA1000T6L
  • NNI 300/147 XL
  • NIQ 290/155 XL
  • NIQ 300/147 XL
  • TUV 325W XPT

(ballasts for other UV lamp types available on request)

ZED Control Units

  • ZCONmini
  • ZCONdin
  • ZCONnano
  • ZCONsub